rear disc brakes on 8 3/4

Buschi340 said

72bluNblu ,
very good Point. Didn't know about that off set. but can't be that much. It is working this way since 3 years. But you are right. I saw that the linings are not centered in the drums. One reason more to Change it to discs. :)
ok, got yukon BBP axles and green bearings already.

mguner,
you did that swap? Parts list, sources etc?

74DartSwinger360,
did you ask right stuff where to buy pads and discs?

Click to expand...

Yeah I posted it here a few times. I can't remember what brake lines I used but they were a common part as well. Speedway motors has braided line kits and banjo fittings along with the weld on caliper brackets and line mount tabs. The Intrepid calipers are a perfect fit to the loaded GM metrics with E-brake and are tight on the 8.75 axle flange which may require just a little taken off the flange or the inside of the rotor hat. If your studs have much of a shoulder you may have to counter bore the lug holes in the rotor too (5/8 or 9/16 bit).