Need some help !!!!!!!!!!!!!!!!!!!!!!!!!

Here are the measurements I got from the intake manifold. As instructed, I sat the intake down on the engine with clean surfaces and no gaskets. I slid the intake to one side and kept pressure on it with one hand to be sure it stayed flush with the head. I was using Edelbrock .060" gaskets.

.042" at first intake bolt hole
.048" at first set of intake runners
.056" at rear intake runners
.0585" at rear intake bolt hole
.055" gap at front between china wall and intake
.050" roughly at rear china wall and intake, kinda hard to measure there.