Dougs 67 Notch build

Below are 6 photos of the sequence wiring the engine bay before installing engine. The first shows the firewall with the two #10's drilled through the bulkhead connector. The 2nd is the factory harness being torn completely apart and redone, all damage repaired. Then there are a couple of the rebuild harness install. The last two show my #10's with crimp-ons waiting for fuse/breaker decision. I also show the auxillary ground bar that is connected to the one under the dash. The one you see will be grounded to the battery negative on the down side of the battery shutoff switch that will be installed in the battery negative cable. Thanks for looking--------DR---------:coffee2:


View attachment Wiring1.jpg

View attachment Wiring2.jpg

View attachment Wiring3.jpg

View attachment Wiring4.jpg

View attachment Wiring5.jpg

View attachment Wiring6.jpg