Need some help !!!!!!!!!!!!!!!!!!!!!!!!!

duster360 said
After reading back through comments made here I thought I would sit the intake down on the engine again with no gaskets. It will sit all the way down on the head gasket tabs. Which gives me .039" gap between china wall and intake. I then slid the intake to one side and had no gap on the drivers side. Passenger side measurements are:

.020" at front water port
.038" at first set of intake ports
.070" at rear intake ports
.086" at rear water port

Pictures and video on the way.

Here is the sliding thing,again.
When things are right, this cannot be done. Something is keeping the manifold from dropping into the valley. Get rid of those tabs,if you have to, until the intake drops down tight to the heads or runs out of room on the china walls..