Old Man's 66 Cuda Funnycar build

View attachment IMG_2147.jpg
Used the cardboard pattern form from the first tub install, placed it in the next tub and traced around it . this is where it will be cut to match the first one .

View attachment IMG_2148.jpg
reversed the tub pattern and taped it together . this will be clamped in place and marked with the contour tool .

View attachment IMG_2149.jpg
2nd shot of the back of the pattern tub .


View attachment IMG_2152.jpg
trimmed the bottom and edges of the tub and installed it . used a 48 inch level to make sure both sides are the same .

View attachment IMG_2153.jpg
Level shows dead on level. drilled holes inside and pop riveted it in place .

View attachment IMG_2154.jpg
nice tight fit on inside of quarter panel .

View attachment IMG_2155.jpg
side shot of installed tub . next up will be filling in the gaps and making a frame for the rear floor area ...