A Body O.D Bell Housing 3743859

you can cut down the retainer part of the release bearing sleave , just down to the hemi / rb size , then if your bellhousing is the smallest retainer size hole , it still will need to be machined to that rb/hemi size , keep in mind this locates the input shaft in the crank , its must be spot on cl to cl , any off set will work the bushing/bearing out , if it is off you will need to use offset dowel pins , like when a aftermarket bellhousing is used . just be very carefull of the release fork mounting on the inside of the bell , it gets very close to it , may have to shave some from that fork bracket . hope it going to work for you . this way all la bellhousing for a833 trannys can work for you .