1967 Cuda FB project

A few more of the big end where the SC pulley will bolt to. Going to cut it in the middle of the 5&1/2" groove. That will sandwich the harmonic balancer pulley.
View attachment WP_20160305_004.jpg
This is the recess for the SC pulley to seat into. I will drill and tap 6 holes for bolts in there too.
View attachment WP_20160305_006.jpg

View attachment WP_20160305_007.jpg
Letting the metal cool for couple hours so I can get an exact measurement without heat added stretch.



Off to sit a few minutes, then remove 5.7 from 300. :blob: