Reworking the 273 Adjustable Rockers

Jad, OK, plug top hole. drill .125 hole aimed right at valve tip. close outer side hole on adjuster side. grooves/hole in middle of groove goes down with that hole slightly offset toward valve side. Good so far! Last question (I promise!). Are you saying there are additional holes in the shaft 90 deg to those grooves/holes that are already on the bottom? I dont think I seen em and you did say to drill NO holes in the shaft. (just wanting to confirm). If so I'm good once I do your rocker mods & leave the shaft as is. Holler when you can. RR