70 Duster power window install

These pics are of right side (passenger side).
Measurements are center to center of holes.
The measurements are as close as I could get and should be within a 1/16". Get some small nuts and bolts, 1/8 or smaller and drill 1/8 holes to start. When you get them mounted good with small bolts you can drill out to 1/4".
Pic. 1 The green circled holes are the holes I drilled for mounting. This reg is out of 80 Cordoba so I had to drill out gear hole for small motor circled red. I drilled this hole 1" I think but could have been smaller, 3/4 may do but you would have to measure gear to be sure. Blue circled holes a factor ones.
Pic.2 I used the factory holes opposite the motor to measure from. The top hole is 7 3/8" . The bottom hole is 6 5/16" from factory hole. The bottom hole you want to center on mount pad as you do not want to blow out the side when drilling 1/4" holes.
Once you get 1st one drilled take other reg and bolt them together mount pad to mount pad, now you can drill 2nd reg as they are a mirror image of each other.
Pic.3 The areas marked in yellow are on the same level and is were the original reg was mounted.The blue area is recessed in deeper and you need to keep new reg above it.
Pic.4 Here you can see the recesses better. The blue holes are factory holes I based my measurements from. The green holes are my new mounting holes. The red holes with X through them are 1st attempt mistake. Bright blue scribble hole is stop adjuster that I put in after this pic.
Pic.5 Measurements are center to center of holes. This is right side. Nut circled blue is stop adjuster, will explain latter.
Pic.6 Left side measurements.
Pic.7 This is the reg track arm. I made it out of 1 1/2 square stock 9 " long. You can make both sides out of 1 peace. I cut it so I had 1/4" lip on both sides to give it more strength.
The holes are 7 1/2" apart. One side is a 1/4 hole that bolts to reg and other hole is 7/16 that gets spring clipped to pivot in door. Ignore the 2 bottom holes.

Stay tuned, will not be posting tomorrow but will be back Sun or Mon night. Case of beer is in my way and it is much to dangerous to drink and type.
Mike
This sucks that I can`t make pics any bigger for some reason.