Rebuilt A998 - No upshift/only 1st gear

Guys,

I pulled the pan and valve body. I performed a air pressure tests, and here are the results: [ame="https://www.youtube.com/watch?v=r4QdFDv2EEg"]A904 - YouTube[/ame]
rear servo - ok
front servo - minor leakage (acceptable?)
rear clutch - minor leakage (acceptable?)
front clutch - massive leak!

I did have concerns regarding some leakage applying air pressure to the front clutch when I tested it on the bench before going in the car, but it was a lot less than now. After the bench test I disassembled it again, all looked good, reassembled again, and got the same results doing the air pressure test. I took a chance to use it, and failed!

Now, is there any specific seal/ring kit I should go for? What about my rear clutch/front servo leakage, is it acceptable?

Thanks!