So the first thing I needed to decide was where to place the turbo. Well that was pretty straight forward after looking at what few options I really had for placement. Then I need to make something for the turbo to set on while the tubes are being fitted. That worked out pretty easy also. A couple of 2x4s cut to sit on the frame rails and a couple of 4x4 blocks wirh a couple of recessed areas to set the turbo into and there it is setting in its new resting place. the 2 tail BOV's will set right up on the inside of the fender as shown in the pictures. they will vent right into the wheel well. and for the exhaust. Well I'm now thinking right out of the tubo and right through the front of the fender. simple clean and just sounds nasty. will run a small resonator but that it. plenty of room up front of the tire. so that's it for tonight.