worried....... a little

It is more uncommon when a cam in a Mopar turns perfectly on the first attempt IMO!

I just had a custom nitrided cam come in and it would barely turn with a large wrench on the end. Out it comes and start mic'ing the journals, of which 3 are .001"+ above the high spec. In the crank polisher it goes and 10 minutes later and the journals are within spec. Installed the cam in the block and it turns beautiful with a couple of fingers. All that being said....

Install your cam it will be fine and live just fine.

If you're curious then pull it out and mic the journals, also put the cam on some V-blocks and set up and indicator to record any runout.

Again just run it. J.Rob