Anders you might want to take the primer out of where the caliper pistons go. 1. it can gum the brake fluid and 2. it can cause the pistons to stick, just put a paper towel in there for the color and make sure the grove for the seal is clean. Hate to say this but where the lca rotate also on the pins can cause it to bind.:rolleyes:
I wanted primer in the groove for the piston boot. I came to the conclusion that it would be easiest to do it this way and clean out the piston bores and seal grooves after painting.
I masked off the surface on the LCA pins where they fit in the K-frame. So you think my urethane bushings will bind even if I grease the pins?