DING! DANG! DAGNABIT! Problems always seem to escalate.
When I went to work on the Barracuda radiator today I saw that I was going to have to remove the fan from the radiator before I could take the shroud off. It was held in place by 4 of those zip-tie looking fasteners that you push through the radiator fins. Naturally, they're a one time use fastener so I nipped the ends off of the one side and pulled them through. The local NAPA had replacements in stock so I thought I was set.
After removing the shroud I went to put the fan back on. - That's when I saw some coolant seeping from the area of one of those pull-through fasteners. Apparently I put to much stress on one when I was trying to cut it off.
I'll have to drain the Evans and take the radiator in to have it repaired tomorrow.:mad::mad::mad: