Can you "fix" a bad top install?
The tension cables run from the front to back along the side rails. Think it att he's to the lower rear section. They are 4-5' long
The small wires are to push the sail panel out when lowering the top.
This picture is from the TSB for convertible top on my dart. Not sure if they used it on the barracuda.
Not sure if you could get that top smooth. One reason to use a pro, to get good results. Had a guy put one on my 67 Coronet convertible and he damaged my new top and caused a lift cylinder to start leaking due to the poor install, or it might have started leaking cause it was old, but I like to blame the guy that did the poor job. My Dart had someone that knew what he was doing and it looked perfect, but he didn't use the bow wires and it wore a hole in the top in 6 months.
The small wires are to push the sail panel out when lowering the top.
This picture is from the TSB for convertible top on my dart. Not sure if they used it on the barracuda.
Not sure if you could get that top smooth. One reason to use a pro, to get good results. Had a guy put one on my 67 Coronet convertible and he damaged my new top and caused a lift cylinder to start leaking due to the poor install, or it might have started leaking cause it was old, but I like to blame the guy that did the poor job. My Dart had someone that knew what he was doing and it looked perfect, but he didn't use the bow wires and it wore a hole in the top in 6 months.
