Electronic Ign/Hei/Ballast Delete Wiring?

TrailBeast said

Are you sure your ballast is wired like the pic shows?
You might have to leave the ballast in the regulator circuit and use the wire that comes of the coil positive as your ignition power.
The thing that concerns me is that the way it shows wired might put a damaging amount of power through your regulator if you tie those two from the bulkhead in your pic together and give the regulator a full 12v.

Click to expand...

Okay, so I'm having the same problem getting my head around this. Yes I'm sure that this is the way my system is wired. When I upgraded to the electronic voltage regulator I used this schematic from allpar




Edited***

Okay, I'm looking at this again. This schematic would have a full 12 volts going to the VR during "run" operation, no?

So, if the blue w/white stripe, and brown from the bulkhead connector were spliced together as in my "Proposed Set Up" diagram, the VR would be getting a full 12 volts all the time, which it is already, right?