thanks for the clearing that up , did you have to do some work on the pistons to clear the counter weights of the crank ? and what c/r are you running , did you have to cut the tops of the pistons ?
I have not gotten that far yet! Ha, but I want to shoot for 9.5-1 to 10-1 compression. Being that the bore is 4.00" now, it has 360 pistons(kb107's) to work with the 360 stroke, so no piston shaving. Once I figure what heads I will run and find my compression out, then I will cam it to make it run on pump gas. The KB 107's are are a pretty tall piston, the machinist told me that by the time he got close to zero deck, the taper in the deck was finally gone. So now it is straight, not sure what my deck height is specifically though. It was last minute that I had my friend take it with him when he brought his 360 block in to get it ready to go 408 stroker.