Heater box cable questions
At this point no i dont. Once i restored the dash and dash wiring and reassembled it, i wrapped it in an old bed sheet, then wrapped that in bubble wrap, and put it in a large cardboard shipping box for storage until i'm ready to reinstall it.
Its been so long i'm not sure if i used a #21 or #10 drill shank to make them. I cut the drill shank long enough so after the cable is attached theres room for the collar on top. The collars were made from aviation type spring drill stops. Just remove the spring, and tip. Keep the collar and set screw. I got them from brown aviation tool supply. About $2.75 each. See pic below.
At this point no i dont. Once i restored the dash and dash wiring and reassembled it, i wrapped it in an old bed sheet, then wrapped that in bubble wrap, and put it in a large cardboard shipping box for storage until i'm ready to reinstall it.
Its been so long i'm not sure if i used a #21 or #10 drill shank to make them. I cut the drill shank long enough so after the cable is attached theres room for the collar on top. The collars were made from aviation type spring drill stops. Just remove the spring, and tip. Keep the collar and set screw. I got them from brown aviation tool supply. About $2.75 each. See pic below.
