1974 barracuda 5.9 swap efi

on my 73 duster i just cut the loop off the trans cross member, right by the inner bolt hole. i had to cut a very small notch in the floor. used ta hammer on the rest lol but not hard when youre actually doing it.. then fab up a new cross member for trans.. i took the drive line to a drive line shop. gave them the measurements from end of trans tail to the end of diff and then how much the shaft sticks out of trans. was only about 100$ and i used the trans lines put of a van with the same trans.. fits perfectly. i think the truck lines that came on mine, ran into the starter and mounts.