Problem with Comp Pro Magnum adjusters.

yellow rose said

Those adjusters are very short. I never like to see the Allen part of the screw be loaded by the lock nut.

Click to expand...

Adjusters that would normally work great in a harland sharp or mopar rocker BARELY work with the comps, they are BARLEY long enough and if you don't measure the push rods accurately at all 4 corners and have the adjusters set exactly where they'll be at proper length rods & lash, it won't be right.
So everyone needs to remember to check the outside corner push rod lengths with 'adjusters set' in running position 'extend PR to take up slack' and then take the sized push rod and check it against the no.3,5,4,6 to make sure its putting the adjusters in the good with 1-2 threads below rockers and 2 above adjuster nut...then note PR length and order.