COP Ignition Development

Yes it is, I checked measurements of drive tang width, length .... It is more compact than starting with mechanical advance distributor. It would be nice to have a custom nipple less cap. If there is interest in the COP system, might be worth the risk of distributor purchase.

I need to take about 0.005" off the upper shaft diameter, and make an aluminum flange adapter, for the shutter wheel attachment. I will mount an aluminum plate over the OEM Hall Sensor to mount the optical pickup for 8-tab wheel. I plan to cut the odd 3-pin connector off, and replace with a MX150 4-pin sealed connector for use with both sensors. They will share +5V and ground. The 3-pin connector pigtail seems unobtainable.