rocker shafts are burnt up

-
Yes i had the loud valve noise also, some of the rockers pretty much welded themselves to the shafts lol. It was a while ago but they were crane gold rockers and like I said it was really cool the machine shop bought me a whole new setup. I hope the OP gets it all figured out and fixed up.
 
How did you make out on the issue ?
Yes just talked to machine shop. The new lifter shafts holes were very small compared to my original ones. They were Harland sharp shafts. All else works good lots of oil coming to top of engine with shafts off. Is is going to put a complete new set on with new lifters. Then check too make sure oil is getting to all lefties. Should be picking it up tomorrow afternoon. At least that is the deadline that I gave them. Lol
 
-
Back
Top