Fork rod
AJ/sFormS is rite, if you are required to run a much longer than stock rod the it WILL most certainly effect the geometry of the linkage. Here is a pic of when my clutch was just a single disc. A longer rod would have "worked" but would have pushed the release bearing sleave slightly off the end of the bearing retainer! Solution=.550 thicker twin disc 10.00. In thos pic the bearing just contacted the diaphragm fingers & the fork is already past it ideal contact area.
AJ/sFormS is rite, if you are required to run a much longer than stock rod the it WILL most certainly effect the geometry of the linkage. Here is a pic of when my clutch was just a single disc. A longer rod would have "worked" but would have pushed the release bearing sleave slightly off the end of the bearing retainer! Solution=.550 thicker twin disc 10.00. In thos pic the bearing just contacted the diaphragm fingers & the fork is already past it ideal contact area.
