Another Mopar Off My Bucket List - Barracuda Fastback
Thanks GTS but I'm afraid I've got a new problem. Before final welding I'd test fit the cross-member to make sure it fit OK. Then I cut my tack welds so I could access the inside for more welds. After I was done putting it back together I ground & sanded it. It hadn't occurred to me that I should have tried fitting it one more time before spritzing on some black.
Well... - apparently the welding process sucked the ends of the cross-member closer together by over 1/4". I can still bolt through the frame on one side but I'll have to tweak it to get the width correct.
:wtf:
Thanks GTS but I'm afraid I've got a new problem. Before final welding I'd test fit the cross-member to make sure it fit OK. Then I cut my tack welds so I could access the inside for more welds. After I was done putting it back together I ground & sanded it. It hadn't occurred to me that I should have tried fitting it one more time before spritzing on some black.
Well... - apparently the welding process sucked the ends of the cross-member closer together by over 1/4". I can still bolt through the frame on one side but I'll have to tweak it to get the width correct.
:wtf: