Another Mopar Off My Bucket List - Barracuda Fastback
I kept fighting the sheet metal for the tunnel until after the sun set. Things are shaping up pretty well. After tacking it all down I was able to trim the excess off and the fit looks good.
After removing the drivetrain again I finished welding the upper half of the cross-member. The sheet metal is clamped in place and if nothing goes wrong I should have it welded tomorrow.
The only real problem I ran into was that one of the bolt inserts in that plastic block started spinning so I was unable to remove the motor mount on the passenger side. :( Those blocks are pretty cheesy but we wouldn't be able to get much done without it.