FITECH EFI TUNING tips, info sharing, ideas, settings, etc...

I will be running the car at the drag strip soon to compare how it runs now vs the previous thermoquad. Once I have those times I am going to swap intakes as I traded a friend for an RPM air gap so I can shed some light on the LD340 vs Air Gap intake comparison. EFI should allow for a true performance comparison I would think.

ENGINE SIZE: 340 (4-speed with 3.23s, LD340)
FITECH SETUP USED: Go EFI 4 600hp
ENGINE VACUUM: I will look at this next time driving the car
CAM SETTING (1,2,3, or 4) AND YOUR CAM SPECS: (3) Lunati Cam 60403
IAC COUNTS @ idle and cruise: I will look at this next time driving the car
TIMING CONTROL: Y/N? Yes, but I have another ready to run Pertronix Flamthrower III dizzy that I want to try as well. I will then determine which ignition setup I like best
IDLE RPM:850rpm
TARGET IDLE AFR: 13.6
ANY ADJUSTED PARAMETERS AND WHY?: No adjustments yet, will fine tune once I determine what ignition route I stay with. I do have the slight popping in the exhaust on decal which can be adjusted out. I will also slow the throttle to idle speed as the motor cut out a couple times when I pressed the clutch coming up to a stoplight. Minor adjustment again.