Cinnamon 75 Duster \

Was just out doing a little investigating. Took off the inner panel of the driver side door. Set the hose up to spray the car. went in from passenger side. good news is I saw NOTHING coming in around the glass. But, Sure enough water is pouring down the center inside the door. also coming in at the back edge where I saw the gap earlier.
Turned off the hose and looked closer. the new fuzzies appear to have firm contact across the glass, BUT(theres that evil word again), I see a slight gap between the outside of the fuzzy seal and where it mounts to the door. HMMMM
To verify, I got a strip of roll caulk (removable) and laid it across the joint. pushed down gently to seal but still easy to clean off, and repeated showering the car. Still saw a few drips, but reduced enough to say absolutely this is the main problem! So here I go again. I will need to get some kind of sealent between there. Maybe add a couple screws... I may also add something at the back end. Piece of leftover trunk seal perhaps.