Lokar Kickdown Adjustment? KICKDOWN LEVER STUCK

yeah that first pic. the little thing on the cable {a stop} can be moved forward provided that the cable has not been trimmed too short. Also, the adjustment up on the carb/cable bracket can be adjusted [again, if there is enough slack in the whole thing]. whats happening is that the cable is being pulled too far. With some slack in the cable it gets pulled less. the cable might sag a little. BTW, the levers can stick because of various reasons. The thing that is different with the LOKAR set up is that it "pulls" the cable instead of like the factory setup, the linkage is being pushed. Dont know what carb you are using but be aware of the lever ratio's on the carb's linkage as this could also cause problems. [go with the recommendations of LOKAR] I guess you could adjust at the tranny also IF you have some room for travel {of the lever}. IMHO Good luck!