AC compressor bracket to 360 aftermarket intake issue

I haven't seen an aftermarket solution for it. I ran into the same issues years ago. The first time I made a custom bracket that attached to two intake manifold bolts. I dug around and found some bolts that had studs on them to mount the custom bracket to. It worked fine but it sure didn't look stock. The other time I had a piece of round aluminum stock welded to the intake that was tapped so the stock support would fit. When I mounted my carb the fuel line interfered with the support rod. I made a custom offset support rod to give me the clearance I needed. I had to do the same for the drivers side of the intake too. At least that one fit right. Both mounts were welded in the stock locations and at the stock mounting heights. I should have mounted the carb up first. I would have just offset the passengers mounting location so it was closer to the valve cover before it was welded on. Then the fuel line would have cleared it just fine.