Anyone experienced with Transgo Shift Kit TF2?

threewood said
Bringing this back from the dead because I have a question...

How do you correctly set the gap between the TV valve plunger and the TV valve cam arm after the TV valve is ground down? On a stock VB plunger is pushed in to stop, tool inserted between the plunger and cam arm and adjusting screw is adjusted.

With the TV valve ground there is no positive stop as the plunger goes in below the VB case and hard stop is non existent??

Edit: Think I figured it out. With the plunger against the spring but not compressing it, measurement between it and the cam arm is .200".
Click to expand...

You push the plunger in like you said, but don't compress the spring. Then you can use a properly sized drill bit as a gauge. I don't recall the size off the top of my head though. It should be in the instructions.