MRL 416 w/Big Mouth heads

RAMM said
Mike, What did you think of the S.S.? Did you blend the horrendous bump where the CNC transitions from the intake flange side to the valve side?

14" vacuum with this kind of power and you call this nice? I call it freakin AMAZING!

Seriously , you could have beat Kaase's 415 Cleveland @ 2015 EMC with this and pocketed an additional 12g's . Unbelievable job! J.Rob

SS was a bit ... flat i guess you would call it. Yes those bumps are in every set of CNC heads I have ever dellt with. They were cleaned up before assembly and install, same on the exhaust side.

Here is a pic of the "BUMP" from another set I did a while back. Fixing this build(from another shop) and bad cam install was worth 50hp.