Missed on this combo?

Cudafever said

I would like to know where the velocity probe was placed in the port to get the 321fps.
If there is a scar or bump in/on the floor were the cnc ended,(probably at the start of the ssr) a piece of 80 grit emory cloth could make a world of difference.
Thanks for the flow bench ###
Did you get a dial indicator on your cam lobes?

Click to expand...

I'm just guessing here but that velocity # 321fps is probably calculated from the CSA and the flow rate so it is an average velocity.

I have blended the "bump" on mine and it helped a very small amount--there is still a trough present and I'm not removing MORE short side to get rid of it. Short of welding the S.S. radius is just not that good. J.Rob