Missed on this combo?

Ironman wrote
So just wondering......can a smaller valve be installed once a 2.08 seat has been cut? Just wondering.

I don't know? If they make a Thick enough one, then maybe, yes.

But that wouldn't fix that vary short, short side(SS)
My question is.....is that heads SS cast that bad, or did they muff it all up with the cnc of the head? That picture don't show how far in, the cnc went on the floor.
How far do the cnc marks go?

As far as the intake valve, do all of them look like that or just the one you took out?
IF it's just one then i would buy a new set of valve seals. And put at least one on that valve guide.