K frame Identification
this is a pretty old thread so i don't think the OP will mind but I pulled a K member from 72 duster. I went to the engine-swap website and still can identify which motor it goes to. After measuring everything it seems the only difference is the passenger side pedestal.
Is there only v8 and s6 K members?
Are the B/RB k members different from the 318/340 k members?
I currently have a 360 in the car with biscuit mounts. It seems if i twisted the biscuit mount 180 degrees on the bracket it might work as the
"center to center" measurement on the one i bout is 19" and the one i know that works is about 17.5. they are a little offset though as well.
My only real question is, "can i use this with my small block 360"?
this is a pretty old thread so i don't think the OP will mind but I pulled a K member from 72 duster. I went to the engine-swap website and still can identify which motor it goes to. After measuring everything it seems the only difference is the passenger side pedestal.
Is there only v8 and s6 K members?
Are the B/RB k members different from the 318/340 k members?
I currently have a 360 in the car with biscuit mounts. It seems if i twisted the biscuit mount 180 degrees on the bracket it might work as the
"center to center" measurement on the one i bout is 19" and the one i know that works is about 17.5. they are a little offset though as well.
My only real question is, "can i use this with my small block 360"?