Installed a beefed up K Frame and Borgeson over the 4th of July

I did the same thing on mine and welded stiffening plates on the lower control arms. I did mine with a tig and made a jig to bolt the K frame to make sure nothing warped. I guess I'm lucky that my work has a large vibratory parts wash tank and a cabinet washer...kind of like a giant dish washer. Cleaned it up real good. Then sand blasted it with a wet blast pressure washer. Impossible to get all the crud out of the crevices but the tig burned right through and made good welds. Wish I would have powder coated it but instead I used VHT Epoxy rattle can paint. Holding up well so far after a year. Did all this help??....can't really tell any difference but it sure looks pretty.