Need help with clutch linkage parts

2nd Brewers. I must have $5-7 hunnert bucks or more in linkages and z bars, covers and inspection plates, boots, clips, hardware etc. etc. etc. from them. They have just about all of it though.

as for linkages there is one from your pedal assy to the z bar, and one from the z bar to the clutch pivot fork. Then there are all the little clips and washers that hold them together. 1 rubber boot on each end (firewall and bell house) You'll need a sheetmetal floor hump, Hopefully you got the shifter and shift linkages with the tranny, but if not you'll need 'em too.

I read a few threads about hydraulic clutches on this site when I was doing mine, but decided to go stock. A LOT of guys have tried to go hyd, and constantly are fooling with it, tuning it and generally farting around with the hyd set up. The stock system isn't sexy, but it works.

Good luck with it. Manuals are where its at!