Finally, my first 360 and goals for it! I'll be asking a lot of questions.

Spent a good amount of time today calibrating the bore gauge and then measure and measure again and finally a triple check. I felt like I got a good hang of using the tools. I did not use a stress plate. I measured each bore in 6 positions (took forever). The biggest number on taper was .0023 and out of round the same, .0023. These occurred one time each. I don't have the patience to write down all the measurements. But the bores look good enough for me. I'm gonna dingle berry hone them myself and get Speed Pro pistons. Have a good evening folks!