273 rocker arm adjustment

important update....

Has anyone here done the drilling in the shafts themselves? How did they drill?

I just talked to Don at OE push rods and he had indicated that i may have a hard time drill those holes because they are hardened (this must have been that coating that i chipped off in in the lathe...EEKKK)

He had mentioned having the holes cut with a EDM (eletrical discharge machining)

He is going to sell me a set of push rods with my measurement of 7.162" end of ball to end of cup (which they said is an acceptable way to measure them)

Also going to buy a couple of the stock shafts from him for 25 each. (he says all the small block mopar racers use buy these shafts from him)

I know you guys are scrambling you get your eclipse sun glasses, LMAO.....(im going to use my a shade 14 welding lense) but when the eclipse is over, i am looking forward to your guys input on my latest keyboard full, i have this week and this weekend to get er dun...yeeehhawww

Thanks guys