1/4" return on sending unit
So I'm going to end up using the bulkhead fitting I already have. Not going to crowd the sending unit, so drilling the tank at the circle in the picture, and keeping it high so it's not always sitting in fuel. Going to attach a 3/8 aluminum tube to the back side of the fitting down to the bottom of the tank to reduce splash. And just plug the 1/4" tube.
By the way had to bend the crap out of the pickup tube on the sending unit, was 2.5" above the tank floor. And fingers crossed on fuel level gauge being accurate.
Would have liked the aftermarket tank much better, but going with the simple quick and cheap fix. Thanks for the input guys!
By the way had to bend the crap out of the pickup tube on the sending unit, was 2.5" above the tank floor. And fingers crossed on fuel level gauge being accurate.
Would have liked the aftermarket tank much better, but going with the simple quick and cheap fix. Thanks for the input guys!