Hey, thanks for the kudos Michael!
As Michael mentioned I have not previously made bushings for the HD units as I did not have a pedals set up to model them on. Mr. Baird was kind enough to send me his so I could get the measurements needed. His clutch and brake pivot shafts were badly worn so I made new shafts out of precision ground stock as well.
Here are a few pics. First of the damaged shafts next to the new replacements.
View attachment 1715088674
View attachment 1715088675
Next is a pic of the new clutch rod welded into place along with the new custom bronze bearings for the brake pivot. The roller bearings for the clutch rod have been installed and are slightly inset so that there is room for the felt washer (not pictured) that keeps any crap out.
View attachment 1715088676
And finally all the parts nested together as they will be in the car. The correct E clip was also supplied. The clutch roller bearings and felt washers were ordered through Brewers, who I have always had very good luck with!
View attachment 1715088677