Finally, my first 360 and goals for it! I'll be asking a lot of questions.

Killer6 said
Hey Dude, checked back in on this thread & wanted to comment....... in the 1st pics of the block, #6(bore#1 & crankpin) there is an area in the bore that appears to have
a circumferential crack or corrosion line, left in the pic...frt. of eng. side of the cyl bore. Optical illusion? Also, what is the new compression ratio target w/the Eddy heads?
There is going to be a difference in intake port from the matched teener ports, but should be fine.

Hi. Could you save and then post up the picture where you see it? Maybe even draw a circle or an arrow? I can't find it in the photos. If I have all the numbers right for the compression calculator, with the heads, speedpro pistons and thin mr gasket It will be 10.29