Question?? I got a new tool today.
Went and used this Grinder on the torsion bar.
10, 15, seconds later, torsion bar cut in two.
Due to the fact that the adjuster bolt, and block, was rusted solid, and wouldn't budge, even with a 3/4 drive heavy duty ratchet.
And no problems cutting it, with all the tension on the bar either, so that myth is out the widow, as far as I'm concerned.
Went and used this Grinder on the torsion bar.
10, 15, seconds later, torsion bar cut in two.
Due to the fact that the adjuster bolt, and block, was rusted solid, and wouldn't budge, even with a 3/4 drive heavy duty ratchet.
And no problems cutting it, with all the tension on the bar either, so that myth is out the widow, as far as I'm concerned.