How to adjust roller rockers w/ hydraulic cam. First start up.

Ok, got my rockers adjusted and properly pre-loaded. I did notice on two rockers there were a couple more threads showing on the adjusters compared to all the rest. I went through the procedure again on those two and the result was the same so I assume its ok.
So today I primed the oil system and did not see any oil at the rockers on either side. Im thinking I need to rotate the crank to line up the oil hole. I was getting 87psi using my hand drill so oil pressure is not a problem. Tomorrow I will try again after bumping the crank a little and see if its just an alignment issue. I would like to see some oil at the rockers before I fire it up for the first time. Any suggestions, or is my theory correct?