67-69 Plymouth Barracuda Wheel Opening Moldings

RedFish said

Far as I know all reproductions are bright aluminum correct for 68,9 . 67 OEM was stainless steel. Did hole locations change with model/material change? I don't know.
I do know if I had to drill out the original screws or otherwise had issues with the OEM holes in the fender, repositioned holes in the new moldings would be a good thing.

Click to expand...

Ok. The way you wrote, "...68,9 . 67 OEM..." made me think you meant all years were stainless.

I know 68 and 69 where aluminum originally.

I've never seen a 67 Barracuda stainless molding. I have a back up 67 Barracuda fender that had aluminum molding, but the fender had been repainted so I can't confirm that was original.

I have seen and own the 67-very early 68 Dart stainless moldings. They have different cross section geometry and have a lip that points slightly outward and sits lower than the 68-up aluminum.

Are you confusing the Dart and Barracuda?

or do you have or seen 67 Barracudas with a different stainless molding. If so, could you show pictures?