273 302 318 340 build
A little more done tonight. After I had drilled small end of connecting rod for oil holes last week, I had to deburr the bushing. I used a piece of rubber fuel line and 1000 grit sand paper. Used same pin for test fit on all 8 rods. Better to mess up 1 vs all 8. All but one fit good. Just the slightest amount of wiggle on one of them. I'll have to check if there is a spec for that. Just enough wiggle to feel it.
Crank to rod journal clearances still need to be checked.
Thanks all.
A little more done tonight. After I had drilled small end of connecting rod for oil holes last week, I had to deburr the bushing. I used a piece of rubber fuel line and 1000 grit sand paper. Used same pin for test fit on all 8 rods. Better to mess up 1 vs all 8. All but one fit good. Just the slightest amount of wiggle on one of them. I'll have to check if there is a spec for that. Just enough wiggle to feel it.
Crank to rod journal clearances still need to be checked.
Thanks all.