6.1 Hemi 69 Barracuda Fastback Father Son Project

JDMopar said

Will the new mount location have enough depth so that the motor mount bolt won't hit the tube thru the k frame? The tube that the lower control arm pin passes thru? Sounds like a good plan if it works out. :thumbsup:

Click to expand...

Picture angles are deceiving. Here is a better angle.
Measures 2.25" from the top of the tube to the bottom of where the new bolt hole will be.
~ 1.625" from the end of the mount bolt to the tube for clearance.
Couldn't want a stronger point to weld to. Will completely remove the original mount down to the bottom perpendicular tube that runs front to back.
It will look like it was meant to be there all along. :thumbsup: