Details to convert pressed piston pin to full-floating?
Just measured the oil hole in a set of custom small block connecting rods I have (Cunningham), looks to be about 5/32". It is so large, the chamfer is minimal. I am not recommending this diameter, just something more to think about. Actually, I might just forget the "hole" idea for a street motor with stock rods.
Just measured the oil hole in a set of custom small block connecting rods I have (Cunningham), looks to be about 5/32". It is so large, the chamfer is minimal. I am not recommending this diameter, just something more to think about. Actually, I might just forget the "hole" idea for a street motor with stock rods.