200-4R Behind a 340 and Reid Bellhousing Build
Trimmed out the center section of the old crossmember. Be sure to do this before you try and mock up. The trans will not go all the way up if you don’t and then you’ll be pulling it back out. I had to loosen both headers in order to allow the Reid bell housing to slip past. It barely fit due to it being much wider than the factory bellhousing.
Trimmed out the center section of the old crossmember. Be sure to do this before you try and mock up. The trans will not go all the way up if you don’t and then you’ll be pulling it back out. I had to loosen both headers in order to allow the Reid bell housing to slip past. It barely fit due to it being much wider than the factory bellhousing.