Tilt front end.
The only smoke involved was from the welder and my cigars..
You can't have inner fenders and you must make a new radiator support. I used 3/8s bar stock for the new core support and to tie the fenders into the pivot.
The pivot is 1 1/4 tube welded to the bumper bracket. 1 5/8 rollcage tube is cut in half and welded to 1/4 x 2 flat stock. I notched the flat stock then welded tabs to the half tube with weld in nutserts.
I will get a better pic of the hinge tomorrow.
The only smoke involved was from the welder and my cigars..
You can't have inner fenders and you must make a new radiator support. I used 3/8s bar stock for the new core support and to tie the fenders into the pivot.
The pivot is 1 1/4 tube welded to the bumper bracket. 1 5/8 rollcage tube is cut in half and welded to 1/4 x 2 flat stock. I notched the flat stock then welded tabs to the half tube with weld in nutserts.
I will get a better pic of the hinge tomorrow.