360 build thread
Got the other head on and have started checking for pushrod length as well as my geometry (using the b3 kit). Heres my procedure please tell me if im doing it wrong.
Rotated til intake #1 lifter at peak this confirms #1 exhaust lifter is on base.
Sharpied valve for exhaust rocker and adjusted rocker adjuster til around 1.5 threads was showing, installed adjustable pushrod tool.
Install rocker shaft with rockers and bolt down. Cam card calls for .006 lash hot so i adjusted the pushrod til around .008 lash cold.
Rotated 2 revolutions and verified sweep. Sweep width was about .0042.
Dont have a dial caliper long enough going to have to borrow one, should i rinse and repeat this procedure for the rest?
Got the other head on and have started checking for pushrod length as well as my geometry (using the b3 kit). Heres my procedure please tell me if im doing it wrong.
Rotated til intake #1 lifter at peak this confirms #1 exhaust lifter is on base.
Sharpied valve for exhaust rocker and adjusted rocker adjuster til around 1.5 threads was showing, installed adjustable pushrod tool.
Install rocker shaft with rockers and bolt down. Cam card calls for .006 lash hot so i adjusted the pushrod til around .008 lash cold.
Rotated 2 revolutions and verified sweep. Sweep width was about .0042.
Dont have a dial caliper long enough going to have to borrow one, should i rinse and repeat this procedure for the rest?